HIGHLIGHTS
  • Resistant to UV-cured, plastisol and solvent-based ink. Water resistant when post-exposed.
  • Medium solids content and medium viscosity for excellent print definition on any mesh.
  • Exposes 4 times faster than diazo or dual-cure emulsions with no mixing required.
  • Blue color emulsion
  • Easy to reclaim
PRODUCT BRIEF

A premium pre-sensitized emulsion for commercial graphics printing.

USAGE INSTRUCTIONS

DIRECTIONS FOR USE:

Handle under yellow safelight or low wattage tungsten lights. Avoid exposure to daylight, quartz/halogen lamps, cool white fluorescent lamps or discharge lamps.

  • Sensitizing & Mixing: Emulsion is pre sensitized during production and does not require mixing.
  • Mesh Preparation & Degreasing: Degrease and abrade new mesh with Degreaser in order to optimize stencil adhesion; dry and store the screen in a dust free, dry environment prior to coating. For more applications, thoroughly degrease the mesh prior to use.
  • Coating: Using a high quality scoop coater or coating through, apply one or two coats to the substrate side of the screen, followed by one or two coats on the squeegee side. For a thicker stencil, apply additional coats to the squeegee side prior to drying. For a higher quality stencil with a minimal increase in stencil thickness, apply one or two additional coats to the substrate side of the screen after the initial coats have dried.
  • Drying & Storage: Thoroughly dry the coated screen at a maximum temperature of 104°F (40°C) in a dust free, dark or yellow light area, with the substrate side facing down to optimize stencil quality. Coated Screens should be stored in a dust free, dry, safelight environment.
  • Exposing: Ensure that all surfaces, emulsion, film and glass are free of dust to minimize pinholes. Contact the emulsion side of the positive with the substrate side of the screen and secure in position before placing the screen in a suitable vacuum frame. Many variables, such as lamp type and age, distance from lamp to screen, mesh type and coating thickness, can affect exposure time. Perform an exposure test with an exposure calculator to determinate correct exposure time for a complete cure.
  • Developing: Wet both sides of the screen with a strong, finely divided spray of water and continue washing out until all image areas are fully open. Rinse both sides of the screen and dry thoroughly before use. A properly exposed and developed screen will not leave residues on the squeegee side.
  • Reclaiming: Remove all ink residues immediately after printing with an appropriate solvent. Remove stencil with Decoater gel (or Powder) with a pressure wash. For stains and ghost images, use Haze Remover followed by a pressure washer.
  • Health & Safety: Before using, refer to appropriate material safety data sheets.